Professional Skipper Magazine from VIP Publications

#92 Mar/Apr 2013 with NZ Aquaculture

The only specialised marine publication in Oceania that focuses on the maritime industry, from super yachts to small craft to large commercial ships, including coastal shipping, tugs, tow boats, barges, ferries, tourist, sport-fishing craft

Issue link: https://viewer.e-digitaleditions.com/i/119485

Contents of this Issue

Navigation

Page 32 of 100

THE LAST SURVIVORS COMPILED BY JERRY PAYNE WO RNZN (RET���D) W hat became of the last of the HDML���s that served our country, patrolling our coast well beyond their intended life expectancy? Most of us older boaties will remember the black and grey 72ft wooden motor launches known as Black Boats that the Navy used for fisheries protection from the 1950���s, until they were replaced in the mid-1980���s with a larger steel vessel. This is a brief history of those amazing boats and the story of one in particular: Q1184, (later HMNZS Paea P3552). DESIGN Prior to WWll the British Admiralty recognised that there was a need for a purpose-built vessel to assist in the defence of ports around the British coast. The design criteria required a wooden vessel, with good seakeeping capabilities, the ability to turn inside the turning circle of a submerged submarine, and capable of dropping depth charges. Early in 1939 a design was submitted by WJ Holt, Chief Constructor of the Naval Construction Department at the Admiralty. It was 72ft in length with a beam of 16ft and a draught of 5ft. There was accommodation for six ratings in the for���ard mess, two petty officers amidships and two officers aft. Armament consisted of twin 20mm Oerlikons, twin Vickers machine guns and six depth charges. The design was approved, and the first Harbour Defence Motor Launch was built at McGruer boatyard in Clynder, Scotland, and commissioned on September 1, 1940. The Britishbuilt launches were powered by twin Gardner 8L3���s of 152 bhp each, giving a top speed of 12 knots. Subsequently, 486 HDMLs were constructed, mainly by yacht builders in the UK and other allied countries. 30 Professional Skipper March/April 2013 The vessel proved to be an excellent seaboat, and the flared bow prevented all but the heaviest seas from coming aboard. The round bilge amidships gave the vessel ch a tendency to roll, much ny to the discomfort of many low who sailed in them. To allow ility, the greatest manoeuvrability, the f h keelson stopped short of the stern b by some 13ft and this, coupled with the large rudders that were fitted, allowed them to turn almost within their own length. The downside of the shortened keelson was that they were difficult to steer in a following sea. The hull was built of planked mahogany using double diagonal construction with oiled calico between each skin. This was riveted to timber frames running from the keel to the gunwale and further strengthened by longitudinal stringers, giving a very strong hull. Five watertight bulkheads athwartships divided the hull into six compartments, any one of which could be flooded and the boat remain afloat. There were six bunks in the for���ard mess: four on the port side and two to starboard. A small galley was situated on the starboard and cooking was done on a small oil fired stove. Four fuel tanks were situated aft of the for���ard mess. Amidships was the engine room with the two main diesel motors and an auxiliary single cylinder Gardner for charging the batteries and the fire and bilge pump. Above the engine room was the chartroom. It contained the chart table, a casual berth and a second steering position.

Articles in this issue

Archives of this issue

view archives of Professional Skipper Magazine from VIP Publications - #92 Mar/Apr 2013 with NZ Aquaculture